1. Remove residues of old sealants (e.g. using REMOVER® TAL). So as to obtain the best results, clean all contact surfaces using TECHNOSOL® and let dry well.
2. If the material to be joined is an inactive metal, or hardening is too slow, use NOVADURIT® AKTIVÁTOR and let dry well.
3. For friction-bearing assemblies – apply the product to the leading edge of the pivot and to the inner surface of the ring. Turn the pivot against the ring when assembling so as to provide for good spreading of the product.
4. For overlap assemblies – apply the product thoroughly to both surfaces to be joined and press the assembly using corresponding pressure.
5. In hot-pressed assemblies, the product should be applied to the pivot, and the ring should be preheated so as to created sufficient clearance to put the ring freely on the pivot.
6. The parts should be kept at rest until the corresponding manipulation strength is reached.
7. For easier dismantling, use local heating to approx. 250 °C and dismantle when hot using recommended tools.
- Fastening of cylindrical joints
- Sets clearances
- High strength
- Maximum joint 0.15 mm
| Chemical type |
urethane methacrylate |
| Colour |
greenish brown |
| Corrosiveness |
none |
| Ignition point |
> 100 °C |
| Maximum joint |
up to 0.15 mm |
| Viscosity |
medium, Ř00 mPas |
| Range of temperatures |
–55 °C to +150 °C |
| Pressure resistance |
25–50 N/mm2 |
| Manipulation time |
10–30 min |
