1. Remove residues of old sealants using REMOVER® TAL. So as to obtain the best results, clean all surfaces (both inner and outer) using TECHNOSOL® and let dry well.
2. If the material to be joined is an inactive metal, or hardening is too slow, use NOVADURIT® AKTIVÁTOR and let dry well.
3. For friction-bearing assemblies – apply the product to the leading edge of the pivot and to the inner surface of the ring. Turn the pivot against the ring when assembling so as to provide for good spreading of the product.
4. For overlap assemblies – apply the product thoroughly to both surfaces to be joined and press the assembly using corresponding pressure.
5. In hot-pressed assemblies, the product should be applied to the pivot, and the ring should be preheated so as to created sufficient clearance to put the ring freely on the pivot.
6. The parts should be kept at rest until the corresponding manipulation strength is reached.
7. For easier dismantling, heat the components up to about 270 °C and dismantle while hot using suitable tools.
- Fastening of cylindrical components
- High strength
- Thermal resistance up to 230 °C
- Maximum clearance up to 0.35 mm
| Chemical type |
urethane methacrylate |
| Colour |
greenish blue |
| Corrosiveness |
none |
| Ignition point |
> 100 °C |
| Maximum joint |
up to 0.35 mm |
| Viscosity |
medium, 7 000 mPas |
| Range of temperatures |
–55 °C to +230 °C |
| Pressure resistance |
20–30 N/mm2 |
| Manipulation time |
10–30 min. |
