DUOTMEL® 310

1. Thoroughly clean, roughen and degrease the application site with TECHNOSOL®.
2. Separate the required amount of material and remove the protective film.
3. Mix the ingredients in clean hands for at least 1 minute so that the color of the material is even. 4. You can also use microtene or latex gloves when working. If the titanium rod cannot be formed (due to low temperature storage), allow it to warm to room temperature. You can speed up the heating process by placing the stick in warm water in a microtene bag. No later than 15 min. after mixing, apply to the surface to be repaired. The mixed epoxy will not immediately have a high bond strength, but will only have a handling strength.
5. Press DUOTMEL® 310 into cracks and holes and remove excess material, preferably with tools soaked in clean water.
6. In order for the surface to be smooth after curing, smooth it while it is still hardened with fingers moistened in soapy water. After 1.5 - 2 hours it reaches the hardness of the metal, in 6 hours it is hardened and can be machined. The material is completely cured within 24 hours.