1. Clean the place of application perfectly, roughen it and degrease it with the TECHNOSOL® product.
2. Extract the required quantity of the mass and remove the protective foil.
3. Knead the component in clean hand so that the mass should be of an even color. Use microtene or latex gloves when working.
4. Working with the mass is possible for 3 minutes at the maximum after kneading it; then it begins setting. It is fully hardened after about 20 minutes.
5. A smooth surface of the cement can be obtained if it is smoothed out with a wet finger before it sets.
- Excellent chemical resistance
- It seals holes and cracks immediately
- It sets quickly
- When set, it can be machined like metal.
| Setting period (at 20 °C) |
20 min. |
| Hardness |
85 (shoreD) |
| Scope of working temperatures |
from –20 °C to 150 °C |
| Tensile strength |
41 MPa |
| Pressure strength |
124 MPa |
| Density (at 20 °C) |
1 165 kg/m3 |
| Specific resistance |
5x1015 Ω/cm |
| Saturated vapor pressure (at 19 °C) |
0 mm Hg |
| Contact with drinking water |
not permanent |
