Clean the surfaces to be glued, remove dust and degrease them. TECHNOSOL® is appropriate for degreasing. Release the bayonet closure of the cartridge and try, by pressing the pistons slightly, whether both components run out evenly. Put on the mixing tip. Apply NOVATIT® to the surfaces to be glued, press them softly against one another, and let dry. It is possible to apply the mixed glue to ona surface only. The mixing tip should remain on the cartridge as the closure. Remove it before further use, try whether both components run out evenly, and then use a new tip.
- Extreme strength
- High thermal resistance
- Resistant to solvents
| Colour of the mixture |
Yellowish gel |
| Ignition point |
11 °C |
| Density |
949 kg/m3 |
| Manipulation strength (20 °C) |
20 minutes |
| Strength 75 % (20 °C) |
60 minutes |
| Strength 100 % (20 °C) |
In 6 hours |
| Total strength of the joint |
Up to 380 kg/cm2 |
| Max. thermal resistance |
–40 °C to +180 °C (up to +200 °C for a short time) |
| Tensile strength to cut |
35–38 N/mm2 |
